Fuel PSU repair
Buy one of these:
and one of these:
and one of these:
The wires are easily removed from the molex using two paper staples that has been straightened out. Moved the necessary wires around according to the scheme below. Keep the female side as it were and moved the wires in male molex. The left hand side in the table is thus the female, ATX side and the right is the male, WTX side.
Using ATX pinout and WTX pinout(look at the alternate one) I made this mapping. I also followed the wires back into the WTX PSU since the purpose of the wires were printed on the circuit board end.
1 -- 1 | +3.3V 2 -- 2 | +3.3V 3 -- 4 | GND 4 -- | NC 5 -- 5 | GND 6 -- 6 | +5V 7 -- 8 | GND 8 -- 11 | PWR_OK 9 -- 7 | 5VSB 10 -- 21 | +12V 11 -- 22 | +12V 12 -- 14 | +3.3V 13 -- 13 | +3.3V 14 -- 20 | -12V 15 -- 15 | GND 16 -- 23 | PS_ON 17 -- 16 | GND 18 -- 9 | GND 19 -- 10 | GND 20 -- | NC 21 -- 17 | +5V 22 -- 18 | +5V 23 -- 19 | +5V 24 -- | NC
Three positions on the male connector has get special treatment:
Pin 3: This is +3.3V sense. If I understand sense lines correctly you have to run the sense line as close to the load as possible for proper function. The sense line on the ATX side shares pin 13 with a +3.3V wire, it is usually a brown slightly thinner cable, but you have to open the PSU to be sure. Cut it and extend it to PIN 3 on the WTX side (it is not shared with any other wire)
Pin 12: This is FANC, it should control fan speed. Read more below
Pin 24 This is FANM, it monitors fan speed. Connect to tachyometer pin on fan:
Next you must swap GND and +12V on the P3 connector. Just to be sure, remove wires from pin 4 and 8. Like so:
1 -- 5 | +12V 2 -- 6 | +12V 3 -- 7 | +12V 4 -- | NC 5 -- 1 | GND 6 -- 2 | GND 7 -- 3 | GND 8 -- | NC
Concerns: The original Fuel PSU has sense lines on +3, +5V and +12V. ATX only on +3V. If accurate +5V and +12V is needed this might be a problem. But according to L1 they are well within margin when the system i idle. The WTX guidlines state that a 460W PSU should deliver 45A on +3.3V. Not many ATX PSU goes over 30A. Similar for +5V The FANC on pin 12 doesn't appear to work as expected. I expected that the wire would go directly to the fan header inside the PSU, but it looks like its going into one of the IC's, but I'm not sure. The FANC line stays put at +3.3V even when the system if powered down. This might be to low to start the fan from the PSU. Which might indicate that it is just a signal wire to a fan controller in the PSU.. but I don't know.. perhaps a good reason to get my oscilloscope out.